Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Upper Arlington Homeowners
A broken garage door spring stops your whole day: the door won’t lift, the car is stuck inside, and every rattle and bang from the opener is a reminder that something heavy is now unsupported. A spring is the counterweight for the door, so when it fails, the door becomes dead weight. We offer emergency garage door service when a spring snaps and same-day repair on the usual torsion and extension jobs. Our technicians have up to 13 years of experience with torsion springs, extension springs, and the safety cables that keep both under control, and we work on the brands you actually see in Upper Arlington garages – Amarr, Wayne Dalton, Clopay, and more. Call (844) 554-0042 for a free estimate.
What Our Garage Door Spring Repair Service Includes
Spring work is the part of the trade that separates a specialist from a generalist. A garage door spring holds hundreds of pounds of tension, and a wrong-sized replacement or a sloppy wind can injure someone or leave the door unbalanced and unsafe. Here’s what each part of our spring service covers.
Torsion Spring Replacement
The torsion spring sits on the shaft above the door and winds and unwinds to lift the full weight of the panels. When it breaks – often with a loud snap followed by a door that suddenly won’t open – you need a matched replacement, not a guess at size. We measure the wire gauge, inside diameter, and length of the existing spring, then install a new torsion spring wound to the correct number of turns. Our technicians have up to 13 years of experience with torsion systems, so they’re not experimenting on your door.

Extension Spring Replacement
Older doors, including plenty of Wayne Dalton and Craftsman setups, use extension springs running along the horizontal tracks on each side. These stretch rather than twist, and they’re the type most likely to fail outside the garage because nobody keeps them in check. We replace them in matched pairs, since a single dying spring pulls the door crooked and wears the other spring faster. We also fit them with new safety cables so a break can’t send the spring flying.

Broken Spring Repair
A broken spring is the reason most people call: the door is stuck, the opener hums but nothing moves, or the door opens a few inches and slams back down. We confirm the spring is actually the failure and isn’t a combined problem with the cables or opener. If the spring is a clean break on one strand, we replace the spring; if the cable is also frayed or the drum is warped, we quote the whole fix before any work starts.

Spring Adjustment
Not every bad spring is broken. A door that’s stiff halfway up, lifts unevenly, or slams shut on its own is often just out of balance. We check the tension and the door’s balance point, then adjust the spring to the manufacturer’s recommended setting. Sometimes the fix is a bit of tuning, which saves you a replacement – we’d rather tell you that than sell you a spring you don’t need.
Safety Cable Installation
Extension springs are supposed to have safety cables running through them to catch the spring if it breaks. Many older doors never had them, and some have cables that have rusted or come loose. We install or replace those cables as part of a spring job, and we check that the attachment points at each end are sound. It’s a small part of the job that makes a real difference if a spring ever lets go.
Spring Inspection
Springs don’t always snap cleanly. They can crack, stretch, or simply lose tension, and the first sign is often a door that’s slightly harder to lift or sluggish close. Our inspection checks for cracks, worn coils, and a door that won’t hold at mid-height. You’ll get a clear read on what’s good, what’s at risk, and what needs replacing, without any upselling.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We’re factory-familiar with eight brands, and each one has its own way of wearing out. Amarr doors tend to use heavier torsion springs for the panel weight, so we match the replacement to the door’s actual mass rather than a chart. Wayne Dalton sets up plenty of extension-spring doors with their own track and drum geometry, and we know where those drums tend to bind. Craftsman and Raynor are also common in Upper Arlington, and each has quirks around spring length and bracket position that we check before a match to the wire gauge.
Whether your door is a LiftMaster or Genie opener system paired with a Clopay or Amarr door, or something you’ve never seen a label for, we can identify the spring and get a matching replacement. We don’t need to guess by eye – the wire gauge, length, and door weight tell us exactly what we’re working with. If you have Amarr, Wayne Dalton, Craftsman, Raynor, or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
Spring failure doesn’t always announce itself. Some of these signs are an emergency, others are a warning. Either way, don’t force the door.
- The door won’t lift, or lifts a few inches and stops. The opener hums but the door doesn’t move, or it moves a little then drops back. That’s the classic sign of a broken torsion spring – stop using the opener and call us, since continuing to run it can burn out the motor and the door can fall.
- A loud snap from the garage. A torsion spring breaking sounds like a gunshot and is hard to miss. If you heard it and the door suddenly feels dead weight, the spring is almost certainly the cause.
- The door feels heavy or slams down. A door that’s hard to lift by hand, or accelerates hard on the way down, is a sign the spring has lost its tension or is failing. That’s a balance problem, and it needs attention before something else breaks.
- Visible gaps or cracks in the spring coil. A cracked or separated coil, or a spring that looks stretched and sagging, is on its way out. Don’t reach in – call a pro and avoid opening the door.
- The door hangs crooked or one side sags. A single failed spring on a pair of extension springs pulls the door off-balance, wearing rollers and tracks. Fix the pair, not one side, so the door stays level.
Our Garage Door Spring Repair Process – Step by Step
We keep the process simple so you know exactly what’s happening and what it costs before we touch a thing.
- 1
Inspect before we quote. We check the springs, cables, drums, and opener, and test the door’s balance by hand. That tells us whether it’s a spring, a cable, or a combination, so the estimate covers the real problem.
- 2
Measure the existing spring. We measure the wire gauge, inside diameter, and spring length, and confirm how many turns the manufacturer calls for. A spring that’s close but not right will wear out fast or leave the door unbalanced.
- 3
Give you a written price first. You get the estimate in writing before any work starts, including the parts and the labor. No surprises when the job is done.
- 4
Replace and install safely. We wind the new spring with the proper winding bars and install or replace safety cables on extension-spring doors. Torsion work is done with the door fully supported so there’s no chance of a drop.
- 5
Test and balance the door. We run the door up and down, check the balance point, and confirm the opener lifts and lowers smoothly before we leave. If the opener is struggling, we’ll flag it then.
How Much Does Garage Door Spring Repair Cost in Upper Arlington?
A typical spring repair in Upper Arlington runs $180 – $340 for one spring, depending on the door and the spring type. A matched pair, which we usually recommend for extension-spring doors and for doors that run on two torsion springs, costs about twice that. If cables are also worn, cable repair runs $130 – $250 on top. Here’s how those numbers break down by job:
| Service | Typical estimated range |
|---|---|
| Torsion spring replacement (one spring) | $180 – $340 |
| Extension spring replacement (one spring) | $180 – $340 |
| Broken spring repair (single) | $180 – $340 |
| Matched pair of springs | About twice the single-spring range |
| Safety cable repair or replacement | $130 – $250 |
| Spring adjustment and balance tune-up | Included in the spring inspection estimate |
What affects the price: the spring type (torsion versus extension), door weight and size, how many springs, and whether cables or drums also need replacing. A single-spring door is cheaper than a double-spring door, and a high-lift or custom-height opening takes more time. If the opener has been running against a broken spring, we may also recommend an opener check – opener repair runs $120 – $320 if it’s been damaged.
How to avoid overpaying: get the estimate in writing, confirm the price covers the parts and labor, and ask whether it’s for one spring or a pair. We’ll tell you if a repair is enough or if the door is far enough gone that replacement makes more sense. Our estimate is free, and the written estimate sets the final price.
See the difference
Before
After
Before
After
Before
AfterGarage Door Spring Repair Near Upper Arlington – Our Service Area
We serve Upper Arlington and the neighborhoods around it, including Grandview Heights, Hilliard, Columbus, Worthington, and Dublin. Response times vary with how busy the day is, but spring calls get priority when a door is stuck open or won’t secure the house. If you’re in Grandview Heights or Hilliard, our garage door spring repair team can usually reach you quickly, and we handle the broader Garage Door Repair Upper Arlington work as well.
Serving Upper Arlington, OH – Our Local Coverage Area
We serve Upper Arlington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Upper Arlington
It’s the replacement or adjustment of the spring that counterbalances your garage door, so the door feels light instead of like dead weight. A torsion spring twists around a shaft above the door; an extension spring stretches along the track on each side. Repair means identifying the spring, matching a new one to the door’s weight, and installing it safely. Call (844) 554-0042 and we’ll tell you which type you have.
Most spring repairs take about an hour to 90 minutes on a standard residential door, including the balance check. A matched pair takes a little longer, and if cables or drums also need work, plan on more time. We’ll give you a realistic window when you book. Get your free estimate by calling (844) 554-0042.
A typical spring repair in Upper Arlington runs $180 – $340 for one spring, and a matched pair costs about twice that. Cable work, if needed, adds $130 – $250. The written estimate sets the final price, so there are no surprises when the job is done. Call (844) 554-0042 for an exact quote – estimates are free.
We’re factory-familiar with eight major brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That means we know where each one wears out and how to match the spring correctly the first time. If your door has a brand we haven’t listed, call us with the model number and we’ll confirm. Reach us at (844) 554-0042.
Yes – spring repair is one of our core emergency services, and we’ll do what we can to get you back up and running today. If you have a snapped spring, don’t run the opener; the door can fall. Call (844) 554-0042 and tell us what happened, and we’ll get you on the schedule as fast as we can.
We stand behind the work, and the specific warranty terms on your spring and labor are spelled out on your written estimate before we begin. Ask us when we quote it and we’ll go over exactly what’s covered and for how long. Call (844) 554-0042 to talk it through.
Clear the floor under the door, keep the area around the car safe, and don’t try to lift the door or touch the spring yourself. If you have the door’s make or model number, have it handy. Make sure someone is available to let us in. Set up your visit by calling (844) 554-0042 free of charge.
Schedule Your Garage Door Spring Repair Service in Upper Arlington Today
Whether it’s a snapped torsion spring or a stubborn extension spring, we can get your door back to lifting smoothly. We offer emergency service, free estimates, and a written price before any work starts. If you’re in Upper Arlington, Grandview Heights, Hilliard, or anywhere nearby, call (844) 554-0042 today and we’ll set it up. For other repair needs, see our garage door spring repair and related service pages.
Related Services Around Upper Arlington
If the problem is bigger than a spring, we handle it all: spring repair for Grandview Heights, garage door repair for panels, tracks, and rollers, garage door opener repair for LiftMaster, Chamberlain, Genie, and Craftsman systems, garage door installation when a repair becomes a replacement, and emergency garage door service when the door is stuck open or hanging. Need something else? Call (844) 554-0042.
Written by the team at Garage Door Repair Upper Arlington.